The Elite Nexus Stand can be set up in one of three ways:

Step 1: Unlock case with keys provided and remove faceplate.

Step 2: Feed cable through the stand and plug in your tablet while placing it into the case.

Step 3: Place faceplate back on and lock. Follow steps 4-6 for adhesive mount

Step 4: wipe base of stand and your mounting surface with alcohol wipes provided and let dry.

Step 5: Place adhesive to the base of stand and firmly place down on your mounting surface. Let the stand sit for 24 hours before use.

Optional cable cutout: Unscrew existing closed cable cutout and install the open cable cutout included with stand.

Optional position lock: Rotate stand 45 degrees so cable hole is on the left, then screw in lock screw as shown. This will lock the rotation.

Step 1: Remove screws from case and lift off stand.

Step 2: Follow the above locations to line up your surface mounting and cable feed.

Step 3: Drill pilot holes to assist with screw base mounting. Refer to the mounting guide for assistance. If running cable through the surface, ensure to drill a large hole to feed cable through.

Step 4: With the cable channel facing out the left hand side of th estand, screw down your stand using the wood screws provided.

Step 5: Place case back on the stand and screw back in the 4 screws.

Step 6: Unlock case with keys provided and remove faceplate.

Step 7: Plug in your tablet while placing it into the case.

Step 8: Place faceplate back on the lock.